How to step on the gas pedal "correctly" to save gas

Many people think that to save gas for their car, they just need to drive less, however, stepping on the gas pedal properly also plays an important role in the process of saving gas... When driving, most drivers have the habit of stepping on the gas pedal and brake comfortably, without paying attention. But this action will easily wear out the brakes, and fuel will be wasted.

To save gas when accelerating a car, drivers should follow these steps:

- The driver will need to press his foot down on the accelerator pedal to start the car,When starting the car, do not be too hasty, press the accelerator slowly.The driver uses the toe of his foot to gently press the accelerator pedal down and waits until the engine starts. Then he gradually reduces the throttle so that the engine runs at idle. To do this, the driver must slowly lift the toe of his foot, at which point the return spring will push the accelerator pedal back to its original position.

- When a car is stationary, it often has a lot of inertia. After starting, if you want the car to move and save fuel, you must increase the throttle gently.to let the car start to increase traction and move. At this time, the engine is very susceptible to sudden shutdown, especially in cases where the car load is large or the road resistance is too large. The way to overcome this situation is to press the accelerator a lot but not too hard.

- When you want to accelerate, the secret is to step on the gas very slowly.Increase the speed of the car gradually, not suddenly. Sudden acceleration can cause the risk of an accident, besides it can also reduce the life of the car and use more fuel.

- If you want to reduce the speed of the car to save the most fuel, the driver should release the accelerator slowly.The speed of the car will gradually decrease in the direction of travel instead of decreasing suddenly. To maintain the movement of the car without accelerating or decelerating for a period of time, pay attention to the speedometer, then adjust the accelerator pedal to a certain speed... Many people think that just keeping the accelerator pedal still will make the car run smoothly, in fact this will make the car run fast and slow because it also depends on the resistance of the road surface.

- In case the driver wants to shift from a high gear to a low gear while driving on the road, remember to increase the throttle to ensure synchronization when shifting gears.This action will help the driver avoid the phenomenon of gears in the car's gearbox making noise, getting stuck or chipped...

By performing the above operations while using the accelerator pedal, the driver will save a significant amount of fuel and increase the life of the vehicle.